San Leandro Fence Co
(510) 662-0626
Fence Repair in San Leandro CA
Not every fence needs to be replaced—sometimes a good repair is all it takes. Whether it’s a section that’s leaning, panels that came loose, or rusted-out metal, we can take a look and fix what’s worth saving. We handle everything from minor touch-ups to more serious structural repairs. If you’re not sure if it’s time for a new fence or just a quick patch-up, we’ll give you an honest opinion and walk you through your options.
Fence Repair Services: 8 Most Common Repairs We Do
Fences take a beating over time—weather, wear, and the occasional accident can all leave their mark. If your fence is leaning, rusted, bent, or has loose sections, it doesn’t always mean you need a full replacement. A solid repair job can often get things back in shape without the cost of starting over. We work on all types of metal fences, fixing everything from broken posts and warped panels to rust spots and sagging gates. Before we do anything, we’ll check out the damage and let you know if a repair makes sense or if it’s better to replace it. No pressure, just a straight answer and quality work if you decide to move forward.
1. Leaning or Tilted Fence Sections
If a section of your fence is starting to lean or sag, that usually means the post footing has shifted, corroded, or come loose. You might notice the tilt getting worse over time or panels pulling away from the post. To fix it, we’ll reset or replace the post and reinforce it with fresh concrete or hardware. This puts the fence back upright and keeps it stable so it doesn’t keep leaning or collapse later on.
2. Rust Spots and Corrosion
Small rust spots can show up on steel and wrought iron fences, especially near welds, joints, or areas where the paint has chipped off. If left alone, that rust spreads. We’ll clean the affected areas, sand down the corrosion, and apply rust-inhibiting primer and new paint. That stops the rust from spreading and protects the fence from future weather damage. If the rust has spread, we can replace damaged areas that are beyond repair.
3. Loose or Missing Fasteners
Over time, screws, bolts, or brackets can work themselves loose or go missing completely. This makes panels rattle, gates sag, or sections start to come apart. We’ll go through the fence hardware, tighten or replace any missing pieces, and make sure everything is secure. This keeps the fence structurally sound and stops further damage from happening.
4. Bent or Warped Panels
Panels can get bent from impact—like someone backing into them—or just from years of pressure and weather. You’ll notice they don’t line up right anymore or might bulge outward. Depending on how bad it is, we’ll either straighten the panels with bracing tools or swap them out entirely. This restores the fence’s shape and strength, and also improves how it looks.
5. Gate Alignment Issues
If your gate is dragging, sticking, or not latching properly, it’s likely out of alignment. Hinges might be worn, the post might have shifted, or the gate frame could be bent. We adjust the hinges, reinforce the post if needed, and fine-tune the latch or frame. That way the gate swings and closes the way it’s supposed to—no more wrestling with it every time you come or go.
6. Broken or Cracked Welds
Welds can crack or break over time, especially on wrought iron or steel fences that take a lot of vibration or movement. If you spot visible cracks or loose joints, those areas need to be rewelded or reinforced. We grind out the old weld, re-weld the joint, and apply rust protection afterward. That brings back the fence’s strength and prevents sections from splitting apart.
7. Fence Post Damage
Posts are what keep the whole fence upright—if one rots out at the base, rusts through, or shifts in soft soil, the structure gets weak. We’ll dig out the damaged post, install a new one, and set it solidly in concrete. That keeps the fence level and secure again, and helps it hold up against wind and pressure.
8. Paint Peeling or Flaking
Chipped or peeling paint isn’t just cosmetic—it exposes the metal underneath to the elements. You’ll usually see this near corners or joints first. We strip off the damaged paint, prep the surface, and apply a fresh coat with weather-resistant paint. This keeps moisture out, prevents rust, and gives the fence a clean, finished look again.
Should You Repair Your Fence or Replace It?
Sometimes it’s obvious when a fence needs help—other times, it’s not so clear. Small issues like surface rust, loose hardware, or a bent panel can usually be repaired without much trouble. If most of the fence is still solid and the damage is limited to one or two spots, a quick repair can add years of life without the cost of starting over. It’s also worth repairing if the style still fits your property and the structure hasn’t shifted too much.
On the other hand, if you’re dealing with widespread rust, multiple leaning sections, or posts that have come loose across large areas, replacement might make more sense. Older fences that have already had several repairs can become more expensive to maintain in the long run. If the structure is failing in more than one spot or if you want to change the style or layout, it might be time to replace it. We’ll take a look and give you an honest recommendation—no upsells, just what makes the most sense for your property.